The Miter Daddy

TMDADDY-3.jpg
TMDADDY-4.jpg
TMDADDY-5.jpg
TMDADDY-6.jpg
TMDADDY-7.jpg
TMDADDY-1.jpg
TMDADDY-2.jpg
44-3.jpg
64837612_2296946930401519_2468107874731783203_n.jpg
TMDADDY-3.jpg
TMDADDY-4.jpg
TMDADDY-5.jpg
TMDADDY-6.jpg
TMDADDY-7.jpg
TMDADDY-1.jpg
TMDADDY-2.jpg
44-3.jpg
64837612_2296946930401519_2468107874731783203_n.jpg

The Miter Daddy

from 250.00

This tool is designed to help you hold thin-wall bicycle tubing in a milling machine vise for mitering operations. It is capable of holding .75” / 19mm tubing all the way up to 1.875” / 47.6mm tubing. It can also hold tapered and non-round tubes.

The Miter Daddy comes in two variants. The standard has one top clamp and is totally acceptable for general use. The Granddaddy variant has two top clamps for even better distribution of clamping forces — especially useful in especially thin wall, hard-to-cut tubing.

For holding smaller tubing, check out The Miter Buddy, which was developed for the small end of seat stays, chain stays, and fork blades.

The body of the tool is 3” wide, which makes it easy to get on the tubing centerline using an edge finder, and if your vise is sloppy you can pack the empty side of your vise with a 1-2-3 block.

With the optional use of a 3/8” dowel pin (included) you can easily pivot the tool in the vise to set the angle, but if you don’t have a Kurt-style vise with 1/2” socket head cap screws, you can remove the pin easily, as it’s only retained with a set screw.

$250 Shipped to U.S. (USPS Priority Mail).
$265 Shipped Internationally
(USPS First Class).

Option:
Quantity:
Add To Cart